Installing multiple rectifiers

In performing this step, be sure to turn off the power to ensure safety. Step 7: Turn on the power supply. After confirming that the high-frequency plating rectifier is installed correctly, it can be operated by turning on the power supply only. My Account Register Log in Wishlist 0. Back Brushless DC Motors. Back AC Servo Motors.

Back AC Gear Motors. Back 3-Phase Asynchronous Motor with Clutch. Back Variable Frequency Drives. Back AC Servo Drives. Back Transformers. Back Isolation Transformers. Back AC Reactors. Back Automatic Transfer Switches Contactors. Back DC Contactors. Back Momentary Push Button. Back Oil Pressure Switch. Back Ultrasonic Distance Sensor. Back Magnetostrictive Sensor. Back Laser Distance Sensors. Back Ring Type Proximity Sensor.

Back Diaphragm Coupling Rigid Coupling. Mount the rectifier shelf. Note the following prerequisites: If more than one shelf is being mounted, first mount the bottom shelf. Adjust mounting brackets, as needed, for different front to back depths. Verify that all cabling length is sufficient for all connections. Verify which mounting brackets you need to use for the rack size, and position the shelf. Secure the shelf to the rack with four mounting screws. Ground the shelf, using the ground lugs included in the rectifier kit from Juniper Networks.

Install the rectifier. Rectifiers should be installed from the left to right shelf position. Slide the rectifier until it connects to the rear of the shelf. You should not connect two rectifiers to the same anode busbar and the same cathode busbar; that will be like being "of two minds" because two different control systems will be fighting to regulate the same system.

Good luck! Appropriate sized diodes in all 4 leads from the two power supplies will prevent current from flowing backwards thru the unit and will solve the problems Ted referred to. It takes a qualified person to determine the correct sizes. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. If you are seeking a product or service related to metal finishing, please check these Directories:.

April A. Regards, Ted Mooney , P. RET Striving to live Aloha finishing. Ted Mooney , P.